Custom Colored Glass Lenses for Airfield Lighting
BO-Glass developed colored glass lenses for a U.S. distributor of airfield lighting components. The project combined glass formulation, molded optical patterns and sample verification to address inconsistent color quality and long sourcing lead times.

The Customer's Challenge
The customer needed a dependable source of glass domes and lenses for its runway and taxiway lighting component range. Color consistency mattered alongside dimensional fit: a change in the glass formulation could alter both the transmitted color and the amount of light reaching the intended viewing direction.
The brief therefore focused on repeatable color, controlled transmission and production to the customer's drawings. BO-Glass's scope was the custom glass component, with samples supplied for the customer's optical evaluation before production.
Developing the Color in the Glass
According to the project record, the lenses used a high-borosilicate base with metal-oxide colorants incorporated into the melt. The color was developed through the glass composition rather than applied as a surface coating.
Sample trials refined the balance between hue and transmission. Batch composition and melting conditions were adjusted, then sample lenses were produced for review. This allowed the team to evaluate the color in the intended lens geometry rather than judging the raw glass alone.

Color Samples and Molded Optical Details
The sample photographs show red, green, amber and clear glass sectors positioned side by side. Their contrasting colors make the molded ribs and surface profiles easier to compare. The customer's drawing defined the component geometry and optical pattern for each part.



Pressing and Annealing for Production
Custom Pressed Geometry
After the sample formulation was agreed, production lenses were pressed to the customer's dimensional drawings. The tooling formed the component profile and its optical ribs together, supporting consistent geometry across the order.
Annealed Glass
The lenses were annealed to relieve internal stress after forming. This project used annealed glass rather than tempering, in line with the customer's preference for the optical components in this program.


Sample Review and Transmission Checks
Illuminated samples supported review of the glass with a light source. The production record also includes an LS182 transmission-meter spot check on a green lens, providing a broadband transmission reading for that sample.
Sample evaluation focused on the interaction between lens color, transmission and the intended light source. The customer's own color and transmission verification formed the basis for accepting the initial samples.


From Initial Samples to More Than 20 Part Numbers
According to the project record, the customer accepted the initial samples after its own color and transmission verification. The supply program subsequently expanded to more than 20 distinct part numbers covering different colors, sizes and molded patterns.
The project established a repeatable route from custom glass formulation to pressed and annealed components, with sample review connecting production choices to the customer's lighting requirements.

Contact Us
Discuss Your Custom Glass Project
Share your drawing, photos or dimensions, together with the intended use and target quantity. We will review your requirements and discuss the next steps.
Sales Enquiries
Email sales@bo-glass.com with your part description, intended use and target quantity.
Send Your Design
Use the form to upload a drawing or describe an existing part. Mark critical dimensions and tell us which surfaces or features matter most.
Request a Custom Glass Quote
Upload a drawing or share dimensions, quantity, intended use and finish. Include any heat, pressure or chemical exposure.
Your drawings remain confidential.
We use the contact details you provide to respond to your enquiry. See our Privacy Policy for more information.
